NEO-6 GPS module connection

Hello all I am brand-new to the SBC craze and I was wondering if someone could give me a guide on how to hook up a neo-6 GPS module to the 40 pin gpio on the le potato. I have been trying to figure it out but have had no success so far any help will be appreciated.

NEO-6 uses UART. Make sure the voltage level coming out of the UART from the module is correct (3.3V and not 5V). Then hook it up to the UART pins on the 40P GPIO. Then use ldto to enable that specific UART. Then tell gpsd to use that UART interface.