Can I hotplug the eMMC module?

[librecomputer]

@freezr

It looks like I have to remove the module, boot from the SD, and then reattach the module, clean it and install something else.

Can I hotplug the eMMC module or it needs to be mount on a powerless state?

Thanks…

You can hot plug the module. Just careful not to short anything.

eMMC (Re)-Detection by Driver Re-Binding

The MMC subsystem driver can unbind and bind devices to re-detect them. eMMC can be hot plugged but require the driver to be re-bound for the driver run through the initial probe again to detect the device. Instead of running the commands manually, you can also use Libre Computer Flash Tool’s b-emmc rebind command which works the same as the manual commands below: sudo ./lft.sh b-emmc rebind # equivalent sudo ./lft.sh b-emmc unbind sudo ./lft.sh b-emmc bind ALL-H3-CC sudo su echo -n 1c11000.…