- Get a good power supply > 5.0V < 5.5V
- Get a good MicroSD card
- If not, you’re going to waste a lot of time.
Introduction
Boot
- Boot Sequence
- General Troubleshooting
- Board Specific Troubleshooting
GPIO Header
- GPIO and Hardware Overlay Control
- Pinout / Pinmux Map
- Python 3 Binding
- I2C
- SPI
- PWM
- UART with 921600 Baud Rate
- SARADC
- I2S - please request if needed
- PCM - please request if needed
- SPDIF - please request if needed
Board Hardware
- LEDs
- Serial Number
- Temperature/Thermal
- IR
- USB Device Mode/OTG
- Power Consumption
- Schematic
Peripheral Hardware Guides
- Waveshare RS485 CAN HAT
- Waveshare HDMI Display with SPI Touch Screen
- ILI9341 320x240 SPI Displays
- ILI9486 480x320 SPI Displays
- Realtek USB WiFi Dongles